Akai FORCE

94
Effects 2
Use this tab to adjust the settings for the Delay, Reverb, Compressor, Pumper and Limiter effects.
Parameter Description
V
alue Range
Delay Time
A
mount of time between the dry signal and the
delayed signal.
1/32 – 8/4
Feedback
A
mount of signal fed back into the delay line. 0–100%
Freq
A
djusts the filter cutoff frequency of the delayed
signal.
0–100%
Mix Wet/dry amount of the delay effect. 0–100%
L/R
Reduces the delay Time in either the Left or Right
stereo field. This is useful for creating offset, panned
delays.
L 50:100 – R 100:50
Reverb Pre-Delay Length of time between dry signal and reverberated
signal.
0.0 – 250.0 ms
Time Length of reverb tail. 0.0 – 30.0 s
Mix Wet/dry amount of the reverb effect. 0–100%
Compresso
r
Threshold Signal level after which the compressor will be
applied.
-30.0 – +10.0 dB
Ratio
A
mount of compression applied. 1.0:1 – 20.0:1
A
ttack Length of time to apply the compression. 0–100%
Output
A
mount of additional output gain for the compressed
signal.
-20.0 – +20.0 dB
Pumpe
r
Rate Speed of the pumper effect. Bar, 1/2 – 1/32T
Depth
A
mount of signal attenuation by the effect. 0–100%
Release
A
mount of time to release the effect. 0–100%
Limite
r
Drive
A
mount of drive added after the limiter effect. 0.0 – 32.0 dB