Akai GX-F51

IV. VOLTAGE AND CYCLE CONVERSION
REAR PANEL
□ C □ □ D
q ..... ___ _,
SYSCON PCB
1. VOLTAGE CONVERSION
Models for Canada, Europe, USA, UK and Australia
are
not equipped with this facility.
Each machine
is preset at the factory according to
destination,
but some machines can be set to 110V,
120V, 220V
or 240V as required.
If voltage change is necessary, this can be accom-
plished
as follows:
1) Disconnect power cord.
2) Loosen holding screws and remove upper cover.
3) Remove short pin plug from present holes and
replace in correct holes. Follow the markings
explicitly.
2. CYCLE CONVERSION
With DC motor, cycle conversion is not necessary.
LI
SHORT PIN
Fig. 4 Voltage Conversion (U Model only)
GX-F31
2-5