Akai GX-F51

SAFETY INSTRUCTIONS
.SAFETY CHECK AFTER SERVICING
Confirm the specified insulation resistance between power cord plug prongs and externally exposed parts of the set is
greater than 10 Mohms, but for equipment with external antenna terminals (tuner, receiver, etc.) and is intended for
~ or [A], specified insulation resistance should be more than 2.2 Mohms (ground terminals, microphone jacks,
headphone jacks. line-in-out jacks etc.)
PRECAUTIONS DURING SERVICING
1. Parts identified by the ~ symbol parts are critical for safety.
Replace only with parts number
specified.
2. In addition to safety, other parts and assemblies are specified for conformance with such regulations as those
applying to spurious radiation. These must also be replaced only with specified replacements.
Examples: RF converters, tuner units, antenna selector switches, RF cables, noise blocking capacitors, noise
blocking filters, etc.
3.
Use specified internal wiring. Note especially:
1)
Wires covered with PVC tubing
2) Double insulated wires
3) High voltage leads
4.
Use specified insulating materials for hazardous live parts. Note especially:
1) Insulation Tape
2) PVC tubing
3) Spacers (Insulating Barriers)
4) Insulation sheets for transistors
5.
When replacing AC primary side components (transformers, power cords, noise blocking capacitors, etc.), wrap
ends
of wires securely about the terminals before soldering.
6. Observe that wires
do not contact heat producing parts (heatsinks, oxide metal film resistors, fusible resiston, etc.).
7. Check that replaced wires do not contact sharp edged or pointed parts.
8. Also check areas surrounding repaired locations.
9.
Use care that foreign objects (screws, solder droplets, etc.) do not remain inside the set.