SP2+ Introduction Manual
- 28 -
Password Checking
Password checking for the Web UI can be turned on/off here, along with the option for specifying the
password for the different user access levels.
After you enable the password checking, you’ll need to re-login.
If you don’t remember the admin password, you can hold the unit’s
reset button for 7-12 seconds to be able to log in to the Web UI
without a password.
User access levels:
Admin - full access to all settings, system and notification configurations (default is public)
User - full access to all settings except for those which are the system-related such as network
Viewer - read-only guest access for every page
Note 1: The passwords can only be set from the unit’s Web UI; this option is not available from APS.
Note 2: The default password is “public” for all access levels.
To Next Page
Loading...
