AKCP SensorProbe2 PLUS - Reset Button Functions

SP2+ Introduction Manual
- 6 -
Reset button functions for SP2+ units
There are specific commands you can send to the unit by holding the Reset button for a specified
amount of time.
You’ll have to use something sharp, such as a straightened paperclip to be able to press Reset.
Commands:
Time to hold
Action
3..7 sec
Reboot
7..12 sec
Web UI password reset
12..17 sec
Serial flash erase (DB erase without factory reset, the system configuration is kept)
17..25 sec
Reset to factory defaults (serial flash erase + config erase)