SP2+ Introduction Manual
- 39 -
Example sensor configuration
Below we’ll show the configuration of 2 sensor types: the Temperature/Humidity and a Relay sensor.
The configuration of these 2 types of sensors covers most settings that can be configured for other
sensor types.
Temperature/Humidity Sensor
Click on the sensor port where the sensor is connected to open the sensor’s configuration.
Note: another way of accessing this page is to click on the sensor from the Summary page.
From this page you can carry out various operations. You can view the current status (normal, low
critical, high critical etc), rename the sensor, put it offline and change the thresholds. In the screen
shot above you can see the sensor is indicating a temperature of 26 degrees °C, and a status of
Normal.
To Next Page
Loading...
