SP2+ Introduction Manual
- 44 -
Advanced sensor configuration for Relay sensors
Control Mode:
1. Manual Control allows you to manually control the relay using the “Sensor Control” option by
controlling the cycle of the relay in an on-off-on or an off-on-off cycle. You can also set the “Toggle”
(Cycle Time) here in seconds.
2. Notification Control allows you to link the relay to an action. The following actions can be chosen in
an action: Turn on until sensor normal, turn off until sensor normal, cycle the relay, turn on until
acknowledged, and turn off until acknowledged. You can also turn the “Sensor Normal Relay State” to
on or off. We’ll explain more about this option in the Notifications manual.
To Next Page
Loading...
