Conguration of the Receiver 16 (36)
Sesam 800 Operating Manual Document-ID: 941211-000
Version: D1 Author: SH
8 CongurationoftheReceiver
8.1 Sesam 800 RX Model
8.1.1 BasicConguration
1. Open the lid on the receiver (6 TX20 screws).
2. Press the Learn/Erase button until LED 7 is ON. The Learn Mode
will be active for 10 seconds (as long as LED 7 is ON).
a. Transmitters Keyring K3 and Small S3: Press button 1 on the transmit-
ter if buttons 1-3 shall be used for activating the relays in the receiver.
b. Transmitter Small S6 and Medium M6:
Press button 1 on the transmitter if button 1-3 shall be used for activat-
ing the relays in the receiver.
Press button 4 on the transmitter if button 4-6 shall be used for activat-
ing the relays in the receiver.
c. Transmitter Large L15: Press the button on the transmitter that shall be
used for activating relay 1 in the receiver.
3. LED 7 on the receiver ashes 3 times if the Learn procedure is successful.
4. Mount the lid on the receiver. Tighten the screws with TX20, torque 2,0
Nm.