Åkerströms SESAM 800 Series User Manual

Conguration of the Receiver 17 (36)
Sesam 800 Operating Manual Document-ID: 941211-000
Version: D1 Author: SH
8.1.2 AdvancedConguration
This conguration allows the user to determine which button activates a specic
relay.
1. Open the lid on the receiver (6 TX20 screws).
2. Press the Learn/Erase button until LED 7 is ON. The Learn Mode will be
active for 10 seconds.
a. Press the Learn/Erase button once in order to select relay one (the status
LED will ash once).
b. Press the Learn/Erase button twice in order to activate relay two (the
status LED will ash twice).
c. Press the Learn/Erase button three times in order to activate relay three
(the status LED will ash three times).
3. Press the button that shall be used for activating the selected relay in the
receiver. If the conguration is accepted by the receiver, LED 7 ashes 3
times.
4. Mount the lid on the receiver. Tighten the screws with TX20, torque 2,0
Nm.
8.1.3 ErasingAllTransmittersintheReceiver
1. Open the lid on the receiver (6 TX20 screws).
2. Press the Learn/Erase button until LED 7 is ON. The Learn Mode will be
active for 10 seconds.
3. Press the Learn/Erase button for 5 seconds (until LED 7 is OFF). All trans-
mitters are now erased from the receiver memory.
4. Mount the lid on the receiver. Tighten the screws with with TX20, torque
2,0 Nm.

Åkerströms SESAM 800 Series Specifications

General

Brand	Åkerströms
Model	SESAM 800 Series
Category	Remote Control
Language	English