AKG PERCEPTION 820 - Powering On and Off

8 PERCEPTION 820 TUBE
3 Setting Up
3.5 Powering Down
five minutes before starting to record. This will allow the tube inside the microphone
to heat up properly,
1. Set the power switch on the Remote Control Unit rear panel to “0”.
The front panel POWER LED will go out.
2. Wait for five minutes to allow the tube to cool down to room temperature before mov-
ing the microphone. A hot tube will be more susceptible to mechanical damage than a
cold one.
Perception_820_Manual_final4_C030818 02/05/2009 11:26 Seite 8 (Schwarz/Black Auszug)