C313W-2Indoor Monitor Administrator Guide
AKUVOX SMART INTERCOM www.akuvox.com
42
Parameter Set-up:
Status: check to see if the SIP account is registered or not.
Account: select Account1 or Account2.
Account Enabled: check to active the registered SIP account.
Display Label: configure the device label to be shown on the device
screen.
Display Name: configure the name, for example, the device’s name to be
shown on the device being called to.
Register Name: enter the SIP account register Name obtained from the
SIP account administrator.
Username: enter the user name obtained from SIP account administrator.
Password: enter the password obtained from the SIP server.
10.4.SIP Server Configuration
SIP server can be set up for device in order to achieve call session through
SIP server between intercom devices. To perform the SIP account setting on
the Web Account > Basic > SIP Server Interface.
Parameter Set-up:
Server IP: enter the Server’s IP address number or its URL.
Port: set up SIP server port for data transmission.
To Next Page
Loading...
Need help?
General
