Connect StatusConnect Status: Display the connection status between the device and the server.
IPIP : Enter the IP address of the server.
PortPort: Enter the port of the server.
PCAPPCAP
PCAP is used to capture the data package going in and out of the devices for debugging and
troubleshooting purposes.
Set up the PCAP on the web Upgrade > Diagnose > PCAPUpgrade > Diagnose > PCAP interface.
Specific Port:Specific Port: Select the specific ports from 1-65535 so that only the data packet from
the specific port can be captured. You can leave the field blank by default.
PCAP:PCAP: Click the Start tab and Stop tab to capture a certain range of data packets before
clicking the Export tab to export the data packets to your Local PC.
PCAP Auto Refresh:PCAP Auto Refresh: If it is enabled, then the PCAP will continue to capture data packets
even after the data packets reach their 1M maximum in capacity. If it is disabled, the PCAP
will stop data packet capturing when the data packet captured reaches the maximum
capturing capacity of 1MB.
New PCAP:New PCAP: Click Start to capture a bigger data package.
To Next Page
Loading...
