Device AddressDevice Address : Specify the device address by entering device location information
from the left to the right: Community, Unit, Stair, Floor, and Room in sequence.
Device ExtensionDevice Extension: The device extension number.
Device LocationDevice Location: The location in which the device is installed and used.
NAT SettingNAT Setting
Network Address Translation(NATNAT) lets devices on a private network use a single public IP address
to access the internet or other public networks. NAT saves the limited public IP addresses, and
hides the internal IP addresses and ports from the outside world.
To enable NAT, go to Account > Basic > NATAccount > Basic > NAT interface.
Stun Server AddressStun Server Address : Enter the server address when the device is in a Wide Area
Network(WAN).
PortPort: The server port.
To set it up, navigate to the web Account > Advanced > NATAccount > Advanced > NAT interface.
UDP Keep Alive Messages Enabled:UDP Keep Alive Messages Enabled: If enabled, the device will send the message to
the SIP server which will recognize whether the device is online.
UDP Alive Messages Interval:UDP Alive Messages Interval: Set the message-sending interval from 5-60 seconds.
The default is 30 seconds.
RPortRPort: Enable the RPort when the SIP server is in a WAN.
To Next Page
Loading...
