LED Light SettingLED Light Setting
LED fill light is mainly designed to reinforce the light at night or in a dark environment.
Set it up on the Device > LED Setting > LED Fill Light Device > LED Setting > LED Fill Light interface.
Mode:Mode:
AutoAuto turns on the LED light automatically.
Aways OFFAways OFF turns off the LED light.
Specific TimeSpecific Time turns on the LED according to the schedule.
Min/Max Photoresistor:Min/Max Photoresistor: Set the minimum and maximum photoresistor value based on
the current actual photo-resistor value detected to control the ON-OFF of the LED light. You
can set the maximum photoresistor value for the LED to be turned on and the minimum
value for it to be turned off.
LED Light StatusLED Light Status
LED display adjustment is used to indicate the light changes of the call button in different states.
The LED status allows users to verify the current mode of the device.
Set it up on the web Device > LED Setting > Light of The ButtonDevice > LED Setting > Light of The Button interface.
LED SettingLED Setting
To Next Page
Loading...
