Device Status:Device Status: There are six statuses, Normal, Offline, Calling, Talking, Receiving, and
Emergency Alarm. The status cannot be changed.
Color:Color: Select from Blue, Red, and Purple. You can select Red & Blue(flashing red and blue
alternately) for Emergency Alarm status.
Display Mode:Display Mode: Set the different flashing frequencies.
LED Setting on Card Reader AreaLED Setting on Card Reader Area
You can enable or disable the LED lighting on the card reader area as needed on the web interface.
Meanwhile, if you do not want to have the LED light on the card reader area stay on, you can also
set the timing for the exact time span during which the LED light can be disabled in order to reduce
electrical power consumption.
Set it up on the Device > LED Setting > Light of The Card ReaderDevice > LED Setting > Light of The Card Reader interface.
Start Time - End Time(Hour):Start Time - End Time(Hour): Set the LED light valid time. If the time is set from 8-
0(Sart time- End time), the LED light will stay on from 8:00 a.m. to 12:00 p.m. for one
day(24 hours).
To Next Page
Loading...
