3.12.1 LAN Port
DHCP Mode
1. In the Network Settings interface, press the softkey to enter LAN Port.
2. In the LAN Port interface, press or key on the phone keyboard to select
DHCP (default is DHCP).
3. Press soft key to enter the DHCP switch interface, it will auto return to last
interface after seconds.
Static Mode
1. In the LAN Port interface, press the or key on the phone keyboard to select
Static IP, then Press soft key to enter Static IP Setting interface and input IP
address.
2. Input the IP address, Subnet mask, Gateway, DNS 1 and DNS 2 in the
corresponding area, Press softkey to save.
3.12.2 PC Port
1. In the Network Settings interface, press or soft key to select PC Port, press
softkey to enter PC Port configuration interface;
2. In the PC Port configuration interface, press or soft key to select Bridge
mode or Router mode;
3. Configured Bridge mode, there will pop-up “Reboot Phone”；Press key to
reboot;（PS：Setting will take effect after reboot）
4. If cancel the reboot, the Settings will be saved but not take effect;
5. Configured Router mode, enter router setting interface, in the values in the
corresponding position;
6. Press key after configuration, the phone will reboot.
To Next Page
Loading...
Need help?
General
