Page
33
AKVA MIRA WITH HEADBOARD
• Assemble the base, position stabilisers and base boards. See instructions for Akva Box.
• Fit the Mira frame by fastening the angle brackets loosely on the upholstered side pieces.
Loosely fit the upholstered foot piece to the side pieces. Hardware bag no. 3 is to be used
above the base boards, bag no. 2 below the base boards.
• Position the headboard on the base and secure it to the frame with angle brackets.
Fasten the corners of the frame one by one. Begin with the screws farthest in.
• When the frame is tightened, it is fastened to the base board with angle brackets in the
middle of each upholstered piece (Hardware bag no. 1.)
• The headboard is secured to the base boards with angle brackets (Hardware bag no. 1)
• Fit the rest of the bed. See instructions for HARDSIDE and INSIDE respectively, beginning
from item (3.) When Inside version: the lower foam is only to be placed on the base
boards, it is not to be secured with Velcro tape.
Hardware bag no:
Hardware bag no:
To Next Page
Loading...
