Page
37
AKVA WELLNESS
• Mount the Benti base (1). See the instructions for Benti bases.
• Mount the power receptacle and holder for the vibration massage control on the Benti
base. Can be mounted on either the left or right side.
• Install the bottom of the bedcover so that the zipper is joined at the head end (2).
Remove the top.
• Place the base plate at the bottom of the bedcover (3).
• Place the foam frame on top of the bottom plate (4).
• Pull out the cables from the heating element and massage units as shown in the drawing
(4). See the instructions for Akva Vital Electronic heating element before assembling it.
•
Mount the safety liner (5).
•
Place the water mattress inside the safety liner (6). See the instructions for water
mattresses.
• After filling the mattress with water, ventilating it and adding Long Life (water
disinfectant) zip the bedcover top onto the bottom (7). See also the instructions for the
bedcover.
• See also separate instructions for the massage unit.
To Next Page
Loading...
