Page 34
AKVA BOXBED
• Base sides and the foot end piece are fitted with the solid wooden legs (1). If the bed is
without headboard, this applies for the head end as well.
• With headboard: fit headboard fittings in the head end of the base sides (2). Fit the solid
wooden legs in the base side (3). Please note: screw from the inside. (4).
• Position the stabilisers inside the base frame as shown in the instructions for AKVA BOX
(item 3 and 4)
• Position the base boards on the base frame. Secure with the fixing paddles. Please note:
the upholstered frame is to be on the outside of the solid wooden legs (5).
• With headboard: fit the headboard by dropping the openings in the bottom of the side
down over the fittings (6).
• Fit the upper half of the bed. See instructions for AKVA SOFT / AKVA JUNIOR beginning
from item (3).
To Next Page
Loading...
