Page
38
AKVA VITAL ELECTRONIC,
max. 250-260 W / 230 - 240 V~
Read these instructions carefully before assembling and using the heating system.
• Position the heating element (1) flat on the bottom of the bed.
• Ensure that no sharp edges damage the heating element.
• Avoid placing the element over differences in level (2).
• The heating element must be at least 10 cm from the side of the bed/side of the foam.
• There must be no foam placed on top of the heating element.
• Place the safety liner (3) directly over the heating element (1) and ensure that it does not
fold at the point where it covers the heating element.
• Place the water mattress (4) in the safety liner (minimum dimensions 40 x 140 cm)
• The heating element must not be switched on until the mattress has been filled
to the normal level.
• After setting the temperature install the protective cover to avoid accidental changes to
the setting.
To Next Page
Loading...
