Alarm.com Smart Thermostat Product Manual | 11
Install Thermostat Body to Back Plate
Verify that any excess wire is tucked back into the
wall to allow room for the thermostat to sit ush
against the back plate.
Press the thermostat body rmly into the back
plate mounted to the wall. Ensure that the pins
on the body are correctly aligned with the header
attached to the terminal board on the back
plate. Failure to do so could cause damage
to the thermostat.
Turn the Power On
Restore power to all the heating and cooling
systems. This can be done at the circuit breaker.
To Next Page
Loading...
