Alarm.Com ADC-T2000 User Manual

Alarm.com Smart Thermostat Product Manual | 13
Congure The System Check The System
The thermostat conguration will be done on
your online account. Here you can congure the
parameters of the system, such as: Heat Pump or
Normal, number of heat and cool stages, heating
fuel, calibration temperature, and congurable
terminal (Z). In your online account, you will have
to enter the thermostat conguration. Refer to
page 9 for the appropriate diagrams when you
set up the thermostat.
While the default settings will be sucient in
most cases, you also have the option to change
advanced conguration settings, such as: Swing,
Dierential, Recovery Setting, Fan Circulation
Period and Duty Cycle, Maximum Set Points,
Minimum Set Points, Thermostat Lock, and
Modes Enabled.
WARNING: Use caution when changing
advanced conguration settings. These
conguration settings should only be changed
by those familiar with heating and cooling
systems’ parameters. Contact a local HVAC
professional for help.
WARNING: Do not test the AC during cold
weather or heat during hot weather. Wait
for mild weather to fully test the system.
To Check Heating
1. Press the MODE ( ) button to select
HEAT ( ) mode.
2. Press the UP  ) button to raise the set point
above room temperature.
3. Wait 5 minutes for the system to turn on.
4. After verifying the heating system is working,
return the set point to the desired temperature.
To Check Cooling
1. Press the MODE button ( ) to select
COOL ( ) mode.
2. Press the DOWN  ) button to lower the set
point below room temperature.
3. Wait 5 minutes for the system to turn on.
4. After verifying the cooling system is working,
return the set point to the desired temperature.

Alarm.Com ADC-T2000 Specifications

General

Brand	Alarm.Com
Model	ADC-T2000
Category	Thermostat
Language	English