12
Enabling motion-detected wake
This setting will enable the thermostat screen
to wake when motion is detected nearby.
1. Press the MENU button.
2. Select SETTINGS.
3. Select USER.
4. Select MOTION.
5. Select ON.
Note: This feature is only available if
the thermostat is AC powered.
Disabling AUTO mode
1. Press the MENU button.
2. Select SETTINGS.
3. Select USER.
4. Select AUTO.
5. Select DISABLE.
Humidity control
The thermoat can adju the humidity level in your
home by directly controlling an external humidifier,
dehumidifier, or by using the cooling syem to dehumidify.
For an external humidifier or dehumidifier, the
thermoat mu be configured to use the Z1 or Z2
terminal. Z1 and Z2 configuration can be found in the
Settings section of the Inaller menu. If a cooling
syem is present without an external dehumidifier,
the thermoat will extend your cooling cycles in an
attempt to reach your dehumidification setpoint.
Changing the humidity mode
Select the mode for which you would
like to control humidity.
1. Press the MENU button.
2. Select SETTINGS.
3. Select USER.
4. Select HUMIDITY.
5. Select MODE.
The modes are OFF, DEHUMID,
HUMID, and AUTO.
AUTO will select either the DEHUMID
or HUMID mode automatically.
6. Select the desired mode.
To Next Page
Loading...
Need help?
General
