14
Ventilation
The thermostat can control a ventilation system
(HRV, VRV, or air baffle) using the Z1 or Z2
terminal. By default, the thermostat will operate
the ventilation system for 15 minutes every hour.
To change the ventilation settings, refer to the
advanced configuration settings through the
Customer Website or Mobile App. If the settings are
not available, please contact your service provider.
Thermostat reconfiguration
If the wiring changes, or if a mistake was made
during initial configuration, the thermostat's
HVAC settings can be reconfigured. This process
will not remove the thermostat from the Z-Wave
network. However, all HVAC settings and
configurations will be set back to their default
values, and the thermostat will present the
user with the initial setup screens again.
Reconfiguring the thermostat
1. Press the MENU button.
2. Select SETTINGS.
3. Select INSTALLER.
4. Select RECONFIG.
Check the system
! CAUTION: Do not te the AC during cold weather
or heat during hot weather. Wait for mild weather to
fully te the syem.
Check heating
1. Press the MENU button.
2. Select MODE.
3. Select HEAT.
4. Press the UP button to raise the setpoint
above room temperature. Wait 5 minutes for the
syem to turn on.
5. After verifying the heating system is working,
return the setpoint to the desired temperature.
To Next Page
Loading...
Need help?
General
