❸ On an Internet enabled device, connect to the Wi-Fi
network ADC-V515 (XX:XX:XX) where XX:XX:XX is the
last six characters of the ADC-V515’s MAC address,
which is located on the camera or on the packaging.
❹ On the same device, open a web browser and enter
http://v515install in the URL field. Follow the on-screen
instructions to add the ADC-V515 to the Wi-Fi network.
The LED will be solid green when the connection
is complete.
❺ Add the device to the account by either selecting the
account in MobileTech or by using a web browser and
entering the following URL: www.alarm.com/addcamera
(you will need the customer user name and password).
❻ Select the camera from the video device list or enter its
MAC address to begin adding the camera. The MAC
address is located on the camera or on the packaging.
❼ Follow the on-screen instructions to finish adding
the camera.
You can now power down the camera and install it in
its final location using the included hardware. You may
configure camera settings from the Customer Website.
WPS mode
To ensure sufficient Wi-Fi signal, complete these
steps with the camera near its final location but prior
to mounting.
❶ Connect the camera’s AC power adapter and plug it
into a non-switched outlet.
❷ Hold down the Reset button on the back of the
camera and release when the LED begins to blink blue
(about 3 seconds).
❸ Activate the WPS mode on the router. The camera will
begin to connect to the Wi-Fi network. The LED will be
solid green when the connection is complete.
❹ Add the device to the account by either selecting the
account in MobileTech or by using a web browser and
entering the following URL: www.alarm.com/addcamera
(you will need the customer username and password).
continued
4
To Next Page
Loading...
Need help?
General
