Albrecht Tectalk Duo - CTCSS; DCS; Channel Settings; Reset to Factory Settings

27
English
7.4. CTCSS / DCS
CTCSS and DCS are procedures for adding an inaudible sub-tone or code to the radio message.
In addition, the device only reacts to incoming radio messages with the corresponding coding.
This means that only users on the same channel with the same CTCSS / DCS conguration
can talk to each other; other radio messages or users on the channel are muted.
CTCCS / DCS is a procedure for a specic addressing of users. Please note that your radio
transmissions may still interfere with or be interfered by other transmissions on the same
channel. We therefore recommend activating the busy channel lockout (see 7.1.2 on page
25).
CTCSS / DCS is not a safeguard or encryption against eavesdropping by others. All radio
transmissions can be clearly received by any other radio device on the same channel.
7.4.1. CTCSS
Congure the desired CTCSS tone for the currently active channel here. The display
corresponds to the frequency of the subtone in Hertz.
7.4.2. DCS
Congure the desired DCS code for the currently active channel here. The display corresponds
to the code sequence used.
7.5. Channel settings
7.5.1. Channel name
Here you can dene an individual name for the current channel, which is displayed on the
main screen. Use the number buttons to enter the name and conrm the change with the
MENU button.
7.6. Language
Choose the language of the menu and the voice prompts between German and English here.
7.7. Version information
Displays the version number of the hardware and software.
7.8. Reset to factory settings
Here you can reset all device settings to the factory settings. This process must be conrmed
once again with the MENU button after selection.