EasyManua.ls Logo

Alcatel-Lucent 1643 AMS - Configuring a Data Communication Network (DCN)

Alcatel-Lucent 1643 AMS
324 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
devices, temperature conditioning, etc.
When not assigned by the customer, the 1643 AM behaves such that MDO 1 has
been assigned to indicate a power failure (normally open contacts will close), MDO
1, MDO 2, MDO 3, MDO 4 are respectively assigned to power failure, Prompt,
Deferred, Information alarms.
Planning considerations 1643 AMS
When planning your system with the 1643 AMS, the following items should be
considered:
Synchronous Capacity two STM-1 aggregate interface ports.
This interface can be equipped with various SFPs (Small Form-factor Pluggable
units): S1.1, L1.1, L1.2, STM-1 e and STM-1 single fiber. All optical SFPs are
equipped with LC connectors.
Plesiochronous Capacity sixteen 2 Mbit/s E1 interfaces or sixteen 1.5 Mbit/s DS1
interfaces (basic unit)
Optional sixteen 2 Mbit/s signals (for a total combination of sixteen DS1 and
sixteen E1 or thirty-two E1)
Optional sixteen 1.5 Mbit/s signals (for a total combination of sixteen DS1 and
sixteen E1 or thirty-two DS1)
Optional two 34 Mbit/s signals (for a total combination of sixteen E1/DS1 and
two E3s)
Optional two 45 Mbit/s signals (for a total combination of sixteen E1/DS1 and
two DS3s)
Optional four X.21 interfaces (for a total combination of sixteen E1/DS1 and
four X.21s)
Optional four 10/100BASE-T LAN interfaces (for a combination of sixteen
E1/DS1 and four 10/100BASE-Ts).
Optional twelve SHDSL electrical tributary interface pairs (for a combination of
sixteen E1/DS1 and twelve SHDSL on 1643 AM / 1643 AMS DC version)
Optional eight Ethernet interfaces in Private Line mode
Synchronization: STM-1 aggregate line interface timing or via a E1/DS1 data input
Protection: VC-12/VC-3 SNC/N
Operations Systems: remote and local management with Lucent OMS and local and
remote (remote to other 1643 AMS) with ITM-CIT, SNMP management is
supported
Three possibilities for Power supply :
DC (unit contains DC connector)
AC (unit contains AC connector)
AC via an external AC/DC connector.
System Planning and Engineering
General Planning Information
...................................................................................................................................................................................................................................
365-312-801R7.2
Issue 3, May 2007
Alcatel-Lucent - Proprietary
See notice on first page
6-3

Table of Contents

Other manuals for Alcatel-Lucent 1643 AMS