Linear applications
...................................................................................................................................................................................................................................
Point-to-point applications without MSP protection
The figure below shows an example of a point-to-point application without MSP
protection.
Point-to-point application with MSP protection
The figure below shows an example of a point-to-point application with MSP
protection. Note that 1 + 1 MSP protection is only available for STM-1 transmission.
LAN-to-LAN linear unprotected application
When cost is a major factor, this application requires a minimum amount of equipment
and fiber. It is well suited for LAN-to-LAN traffic on campus networks or between
business locations requiring cost-effective and reliable communications. Management
requirements of this application are minimal.
Network Topologies
...................................................................................................................................................................................................................................
3-2
Alcatel-Lucent - Proprietary
See notice on first page
365-312-801R7.2
Issue 3, May 2007
To Next Page
Loading...
