EasyManua.ls Logo

Alcatel-Lucent 1643 AMS - Concepts

Alcatel-Lucent 1643 AMS
324 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
System specifications
...................................................................................................................................................................................................................................
Optical Interfaces/SFPs
STM-1
The table below lists some parameters and the end of life power budgets for the fixed
STM-1 optical interfaces that are supported by the 1643 AM and STM-1 SFP cages
that are supported by the 1643 AMS:
Application S-1.1 L-1.1 L-1.2
Operating wavelength range 1260-1360 nm 1270-1360 nm 1480-1580 nm
Transmitter at reference point S
Source type MLM SLM / MLM SLM
Spectral width at -20 dB (max) NA 1 nm (SLM) 1 nm
RMS spectral width (max) 7.7 nm 3 nm (MLM) NA
Side mode suppression ratio (min) NA 30 dB / NA 30 dB
Mean launched power (max) -8 dB 0 dB 0 dB
Mean launched power (min) -15 dB -5 dB -5 dB
Extinction ratio (min) 8.2 dB 10 dB 10 dB
Mask of the eye diagram of the
optical transmit signal
see G.957 see G.957 see G.957
Optical path between points S and R
Maximum dispersion 96 ps/nm NA / 246 ps/nm NA
Attenuation range 0 - 12 dB 10 - 28 dB 10 - 28 dB
Minimum optical return loss of the
cable plant at point S including the
optical connector
NA NA 20 dB
Receiver at reference point R
Sensitivity (min) at BER=1×10
-10
-28 dBm
-34 dBm (aggregate only)
-34 dBm -34 dBm
Overload (min) -8 dBm -10 dBm -10 dBm
Optical path penalty < 1 dB < 1 dB < 1 dB
Optical return loss of the receiver
(min)
NA NA 25 dB
Note: 1643 AM STM-1 (Aggregate and tributary) or STM-4 optical access is via an
SC-type connector. Adaptors FC and ST are also supplied.
1643 AMS: All optical interfaces are available as SFPs (Small Form-Factor Pluggable
Optics) for STM-1 transmission only.
Note that the 1643 AM supports S1.1 and L1.2 interfaces for STM-1 transmission,
whereas, the 1643 AMS only supports S1.1, L1.1, and L1.2 SFPs. The 1643 AMS does
not support STM-4 transmission.
Technical Specifications
...................................................................................................................................................................................................................................
10-2
Alcatel-Lucent - Proprietary
See notice on first page
365-312-801R7.2
Issue 3, May 2007

Table of Contents

Other manuals for Alcatel-Lucent 1643 AMS