EasyManua.ls Logo

Alcatel-Lucent 1643 AMS - Page 250

Alcatel-Lucent 1643 AMS
324 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Interworking with third party equipment
1643 Access Multiplexer AM / 1643 Access Multiplexer Small AMS supports the
following types of third party SHDSL equipment:
E1 Network Termination Units (NTUs) for E1 over SHDSL
E1 NTUs for TU-12 over SHDSL
Ethernet NTUs
SHDSL Regenerator Units (SRUs) (up to two per LTU port)
The following table gives an overview of the features support in dependence of the
release and the SHDSL option card:
Releases 1.0 to 5.0/previous
X12SHDSL option card
(CC109177204)
Release 6.1/new X12SHDSL
option card (CC109579912)
or previous X12SHDSLoption
card (CC109177204)
Release 6.1/new X12SHDSL
option card (CC109579912)
support of TU-12 mode and E1
NTUs for TU-12 over SHDSL
(NT2M)
support of TU-12 mode and E1
NTUs for TU-12 over SHDSL
(NT2M)
SW download to NTU possible
support of E1 mode and E1
NTUs for E1 over SHDSL
(NT2M)
support of E1 mode and E1
NTUs for E1 over SHDSL
(NT2M)
support of Ethernet NTUs
(NT10ETH)
SW download to NTU possible
support of SRUs SW download to SRU possible
support of a certain set of third
party SHDSL equipment (for
detailed information, please
contact the local sales
organisation of Alcatel-Lucent.)
support of a certain set of third party SHDSL equipment which is
different from the one offered in previous releases (for detailed
information, please contact the local sales organisation of
Alcatel-Lucent.)
Important! Please note that an in-service upgrade of the SHDSL option card from
an older release to Release 6.1 and later versions is not possible. It is always
necessary to unassign the X12SHDSL card completely, so that all connections are
removed. Then the upgrade can be done and the X12SHDSL card can be assigned
and configured from scratch.
E1 and TU12 payload mapping
The 1643 Access Multiplexer AM / 1643 Access Multiplexer Small AMS LTU supports
two types of payload mapping into the SHDSL signal:
E1 mode, maps an E1 directly into the SHDSL signal
TU-12 mode, maps a TU-12 containing a VC-12 into the SHDSL signal. The
VC-12 may contain various signal types, e.g. E1, Ethernet data, etc.
SHDSL Overview
SHDSL configurations
....................................................................................................................................................................................................................................
12-4
Alcatel-Lucent - Proprietary
See notice on first page
365-312-801R7.2
Issue 3, May 2007

Table of Contents

Other manuals for Alcatel-Lucent 1643 AMS