Root Commands
7450 ESS OS Basic System Configuration Guide Page 141
area area-id — The OSPF area ID, expressed in dotted decimal notation or as a 32-bit decimal integer.
interval seconds — Configures the interval for each display in seconds.
Default 5 seconds
Values 3 — 60
repeat repeat — Configures how many times the command is repeated.
Default 10
Values 1 — 999
absolute — When the absolute keyword is specified, the raw statistics are displayed, without processing.
No calculations are performed on the delta or rate statistics.
rate — When the rate keyword is specified, the rate-per-second for each statistic is displayed instead of the
delta.
group
Syntax group grp-ip-address [source ip-address] [interval interval] [repeat repeat] [absolute | rate]
Context monitor>router>pim
Description This command monitors statistics for a PIM source group.
Parameters grp-ip-address — The IP address of an multicast group that identifies a set of recipients that are interested in
a particular data stream.
source ip-address — The source IP address to use in the ping requests in dotted decimal notation.
Default The IP address of the egress IP interface.
Values 0.0.0.0 — 255.255.255.255
interval interval — Configures the interval for each display in seconds.
Default 10 seconds
Values
10|20|30|40|50|60
repeat repeat — Configures how many times the command is repeated.
Default 10
Values 1 — 999
absolute — When the absolute keyword is specified, the raw statistics are displayed, without processing.
No calculations are performed on the delta or rate statistics.
rate — When the rate keyword is specified, the rate-per-second for each statistic is displayed instead of the
delta.
To Next Page
Loading...
