Alcatel-Lucent 7450 ESS-12 - Page 128

Root Commands
7450 ESS OS Basic System Configuration Guide Page 147
absolute — When the absolute keyword is specified, the absolute rate-per-second value for each statistic is
displayed.
rate — When the rate keyword is specified, the rate-per-second for each statistic is displayed instead of the
delta.
Sample Output
A:ALA-12# monitor service id 100 sdp 10 repeat 3
===============================================================================
Monitor statistics for Service 100 SDP binding 10
===============================================================================
At time t = 0 sec (Base Statistics)
-------------------------------------------------------------------------------
I. Fwd. Pkts. : 0 I. Dro. Pkts. : 0
E. Fwd. Pkts. : 0 E. Fwd. Octets : 0
-------------------------------------------------------------------------------
At time t = 11 sec (Mode: Delta)
-------------------------------------------------------------------------------
I. Fwd. Pkts. : 0 I. Dro. Pkts. : 0
E. Fwd. Pkts. : 0 E. Fwd. Octets : 0
-------------------------------------------------------------------------------
At time t = 22 sec (Mode: Delta)
-------------------------------------------------------------------------------
I. Fwd. Pkts. : 0 I. Dro. Pkts. : 0
E. Fwd. Pkts. : 0 E. Fwd. Octets : 0
-------------------------------------------------------------------------------
At time t = 33 sec (Mode: Delta)
-------------------------------------------------------------------------------
I. Fwd. Pkts. : 0 I. Dro. Pkts. : 0
E. Fwd. Pkts. : 0 E. Fwd. Octets : 0
===============================================================================
A:ALA-12#
vrrp
Syntax vrrp
Context monitor>router
Description This command enables the context to configure criteria to monitor VRRP statistical information for a VRRP
enabled on a specific interface.
instance
Syntax instance interface interface-name vr-id virtual-router-id [interval seconds] [repeat repeat]
[absolute | rate]
Context monitor>router>vrrp
Description Monitor statistics for a VRRP instance.
Parameters interface-name — The name of the existing IP interface on which VRRP is configured.