System Management
7450 ESS OS Basic System Configuration Guide Page 325
Parameters contact-name — The contact name character string. The string can be up to 80 characters long. Any
printable, seven-bit ASCII characters can be used within the string. If the string contains special
characters (#, $, spaces, etc.), the entire string must be enclosed within double quotes.
coordinates
Syntax coordinates coordinates
no coordinates
Context config>system
Description This command creates a text string that identifies the system coordinates for the device location. For
example, the command coordinates “37.390 -122.0550" is read as latitude 37.390 north and longitude
122.0550 west.
Only one set of coordinates can be configured. If multiple coordinates are configured, the last one entered
overwrites the previous entry.
The no form of the command reverts to the default value.
Default none — No coordinates are configured.
Parameters coordinates — The coordinates describing the device location character string. The string may be up to 80
characters long. Any printable, seven-bit ASCII characters can be used within the string. If the string
contains special characters (#, $, spaces, etc.), the entire string must be enclosed within double quotes.
If the coordinates are subsequently used by an algorithm that locates the exact position of this node then
the string must match the requirements of the algorithm.
dns
Syntax dns
Context config>system
Description This command configures DNS settings.
address-pref
Syntax address-pref {ipv4-only
no address-pref
Context config>system>dns
Description This command configures the DNS address resolving order preference. By default DNS names are queried
for A-records only (address-preference is IPv4-only).
To Next Page
Loading...
