System Management
7450 ESS OS Basic System Configuration Guide Page 403
MC Endpoint Commands
mc-endpoint
Syntax [no] mc-endpoint
Context config>redundancy>multi-chassis>peer
Description This command specifies that the endpoint is multi-chassis. This value should be the same on both MC-EP
peers for the pseudowires that must be part of the same group.
The no form of this command removes the endpoint from the MC-EP. Single chassis behavior applies.
bfd-enable
Syntax [no] bfd-enable
Context config>redundancy>multi-chassis>peer>mc-ep
config>router>rsvp
config>router>bgp
config>router>bgp>group
config>router>bgp>group>neighbor
config>redundancy>multi-chassis>peer>mc-ep
Description This command enables the use of bi-directional forwarding (BFD) to control the state of the associated
protocol interface. By enabling BFD on a given protocol interface, the state of the protocol interface is tied
to the state of the BFD session between the local node and the remote node. The parameters used for the
BFD are set via the BFD command under the IP interface.
The no form of this command disables BFD.
Default no bfd-enable
boot-timer
Syntax boot-timer interval
no boot-timer
Context config>redundancy>multi-chassis>peer>mc-ep
Description This command configures the boot timer interval. This command applies only when the node reboots. It
specifies the time the MC-EP protocol keeps trying to establish a connection before assuming a failure of the
remote peer. This is different from the keep-alives mechanism which is used just after the peer-peer
communication was established. After this time interval passed all the mc-endpoints configured under
services will revert to single chassis behavior, activating the best local PW.
The no form of this command sets the interval to default.
To Next Page
Loading...
