Alcatel-Lucent 8038 - Bluetooth Accessory Setup; Forced Headset Mode; Installing Bluetooth Handset; Using Bluetooth Handset

42
8.18 Activating/Deactivating “Forced headset“ mode
 Reach the “Menu“ page
 Settings Phone ForcedHead
 ON/OFF activating/deactivating forced headset
8.19 Installing a Bluetooth® handset (matching)
Before a Bluetooth® headset can be used, it must be correctly matched to the terminal.
 Reach the “Menu“ page
 Settings Phone Bluetooth Adddevices
 With the handset turned off, press the 2 Bluetooth® handset keys at the same time
(long press)
You will hear a 3 note signal and the LED will flash green and orange alternately
Searching for Bluetooth® equipment. Wait for the detected equipment type and address to be
displayed
 Select the relevant equipment
 Add The 3-note tone indicates that the handset has been installed correctly (the LED flashes
green or orange depending on the battery charge level)
Error messages
The Bluetooth® handset emits a sequence
of 4 beeps
Your set is an older generation than your
Bluetooth® handset
The set displays an error message indicating
that the set and the Bluetooth® handset are
incompatible
Your Bluetooth® handset is an older
generation than your set
8.20 Use of the Bluetooth® handset
The Bluetooth® cordless handset permits the user to answer and converse with complete freedom
within a radius of 10 meter from the set.
The handset has a LED and two buttons.
Light
 Green flashing: normal operation.
 Green steady: handset charging.
 Orange flashing: battery charge low or handset outside coverage zone.
 Orange steady: malfunction.