9 Use the telephone in SIP or “Safe “
mode
Your telephone is compliant with the SIP standard and can be used in simplified mode in a SIP
environment.
According to the configuration the telephone system of your company, your phone set can
automatically switch to “safe “ mode in case of loss of connection with the system, in order to ensure
continuity of service. Then, your telephone is running in SIP mode until the connection with the
telephone system of your company is re-established.
In SIP mode, each telephone is identified by a character string called the URI. Within your company,
the URI of your caller is usually the caller’s telephone number.
For more information, contact your installer or administrator.
The SIP mode is only available for 8 Series.
Pre-programmed function keys are disabled in SIP mode.
9.1 Making a call
Take the line
Use one of the following:
Lift the receiver Enter the destination number
Hands free Dial the destination number
Line key Dial the destination number
You hear a tone
Call by dialing internal number of your caller
Use one of the following:
Dial directly the number for your call
Take the line Dial the destination number Call
Call using your caller's URI
Take the line
Dial by URI
Enter your caller's URI
/ Call
In SIP mode, each telephone is identified by a character string called the URI. Within your company,
the URI of your caller is usually the caller’s telephone number.
To Next Page
Loading...
