7.21 Installing a Bluetooth® Wireless Technology handset (pairing)
This feature is only available with compatible Bluetooth® deskphone. Otherwise the corresponding menu
is not displayed or is inactive.
Before a Bluetooth® headset can be used, it must be correctly paired to the terminal.
Use one of the following:
o
o (long press) Bluetooth
Search devices
With the handset turned off, press the 2 Bluetooth® handset keys at the same time (long
press).
You will hear a 3 note signal and the LED will flash green and orange alternately.
Searching for Bluetooth® equipment. Wait for the detected equipment type and address to be
displayed.
Select the relevant equipment: ALE BT Handset.
Add
Enter the PIN code of the device if necessary. The default password is 0000.
Confirm The 3-note tone indicates that the handset has been installed correctly. The LED
flashes green or orange depending on the battery charge level.
Error messages
The Bluetooth® handset emits a sequence of
4 beeps
Your set is an older generation than your
Bluetooth® handset
The set displays an error message indicating
that the set and the Bluetooth® handset are
incompatible
Your Bluetooth® handset is an older
generation than your set
7.22 Use of the Bluetooth® handset
The Bluetooth® Wireless handset is only available with compatible Bluetooth® phones.
The Bluetooth® cordless handset permits the user to answer and converse with complete freedom within
a radius of 10 meter from the set.
The handset has a LED and two buttons.
Switch on/off
Switch on / off the Bluetooth® handset: long press on the off-hook/on-hook key.
Light
Green flashing: normal operation.
Green steady: handset charging.
Orange flashing: battery charge low or handset outside coverage zone.
Orange steady: malfunction.
To Next Page
Loading...
