You do not use a DHCP serv-
er
Static mode - Refer to table: Initialization
procedure
- Obtain from your network
administrator:
• An IP address for the
IP Touch set
• The subnetwork mask
• The router address
• The TFTP server ad-
dress, which is the IP
address of the Power-
CPU board embedding
the VoIP board
Initializing the IP Touch set
To initialize the IP Touch set, refer to the table below.
Note 1:
In each of the three cases below, you can view the IP Touch set's software version after Step 2 by
selecting Version in the Main menu.
table 4.27: Initialization procedure
For an initializa-
tion that is
Procedure
Dynamic Alcatel-
Lucent Enter-
prise
1. If necessary, enable the OmniPCX Office DHCP server (in OMC, Hardware and
Limits > LAN/IP Configuration > DNS/DHCP)
2. Connect the power supply.
3. After initialization phase 2 is completed and before phase 5 starts, press i, then
the # key.
The Main menu appears.
4. If the set was previously in static mode, select IP Parameters from the Main
menu.
The IP Parameters menu appears.
5. Select Dynamic and press the OK key.
6. Save by pressing the # key.
7. Exit the Main menu by pressing the * key.
Dynamic mode 1. Connect the power supply.
2. After initialization phase 2 is completed and before phase 5 starts, press i, then
the # key.
The Main menu appears.
3. If the set was previously in static mode, choose IP Parameters from the Main
menu.
The IP Parameters menu appears.
4. Choose Dynamic and press the OK key.
5. Save by pressing the # key.
6. Exit the Main menu by pressing the * key.
&'(
4-61
To Next Page
Loading...
