Connecting the set
This section describes how to connect an 8002/8012 Deskphone set to the LAN (Local Area
Network).
To connect the set to the LAN:
1. Plug an RJ45 cable between the set LAN connector and a port of the switch.
Accessing the set administration menu
1. Connect the set to the LAN
2. During set initialization (steps 1/5 to 5/5) , press the *, then # keys
If the set password is required, enter the set password and press OK
Note 1:
The default password is 000000, and after a connection to OmniPCX Office, if not modified, 123456.
The set administration menu is displayed.
Note 2:
When the set is started, the administration menu is available from the Settings > Admin Settings menu.
Initializing the sets
The following paragraphs describe how to:
- Select the initialization type
- Initialize the 8002/8012 Deskphone set
Selecting the initialization type
The default initialization is dynamic.
To select the initialization type, refer to the following table.
table 4.16: Initialization type selection
If Then the required ini-
tialization type is
Further information
You use OmniPCX
Office DHCP server
Dynamic or Proprietary
Dynamic
- Refer to Configuring OmniPCX Office
DHCP server
You use another DH-
CP server
Dynamic - Refer to Configuring an external DHCP
server for dynamic initialization
&'(
4-35
To Next Page
Loading...
Need help?
General
