Alcatel-Lucent OmniSwitch 6450 - Page 352

SNMP Traps Table SNMP Trap Information
page B-24 OmniSwitch 6250/6450 Switch Management Guide June 2013
147 alaHashCollisionTrap ifIndex,
ddmNotification-
Type
ddmRxOpti-
calPower
port This trap is sent when an SFP/
XFP/SFP+ Rx optical power has
crossed any threshold or reverted
from previous threshold violation
for a port represented by ifIndex.
It also provides the current real-
time value of SFP/XFP/SFP+ Rx
optical power.
ifIndex—The interface index.
ddmNotificationType—The trap type for monitored DDM parameters (clearViolation(1), highAlarm(2),
highWarning(3), lowWarning(4), lowAlarm(5).
ddmRxOpticalPower—The current Received Optical Power of the SFP/XFP in 10s of milli-Watts (mW).
148 alaLbdStateChangeToShutdown ifIndex,
ddmNotification-
Type
ddmRxOpti-
calPower
port This trap is sent when an SFP/
XFP/SFP+ Rx optical power has
crossed any threshold or reverted
from previous threshold violation
for a port represented by ifIndex.
It also provides the current real-
time value of SFP/XFP/SFP+ Rx
optical power.
ifIndex—The interface index.
ddmNotificationType—The trap type for monitored DDM parameters (clearViolation(1), highAlarm(2), high-
Warning(3), lowWarning(4), lowAlarm(5).
ddmRxOpticalPower—The current Received Optical Power of the SFP/XFP in 10s of milli-Watts (mW).
149 alaLbdStateChangeForClearViola-
tionA
ifIndex,
ddmNotification-
Type
ddmRxOpti-
calPower
port This trap is sent when an SFP/
XFP/SFP+ Rx optical power has
crossed any threshold or reverted
from previous threshold violation
for a port represented by ifIndex.
It also provides the current real-
time value of SFP/XFP/SFP+ Rx
optical power.
ifIndex—The interface index.
ddmNotificationType—The trap type for monitored DDM parameters (clearViolation(1), highAlarm(2), high-
Warning(3), lowWarning(4), lowAlarm(5).
ddmRxOpticalPower—The current Received Optical Power of the SFP/XFP in 10s of milli-Watts (mW).
150 alaLbdStateChangeForAutoRecovery ifIndex,
ddmNotification-
Type
ddmRxOpti-
calPower
port This trap is sent when an SFP/
XFP/SFP+ Rx optical power has
crossed any threshold or reverted
from previous threshold violation
for a port represented by ifIndex.
It also provides the current real-
time value of SFP/XFP/SFP+ Rx
optical power.
ifIndex—The interface index.
ddmNotificationType—The trap type for monitored DDM parameters (clearViolation(1), highAlarm(2), high-
Warning(3), lowWarning(4), lowAlarm(5).
ddmRxOpticalPower—The current Received Optical Power of the SFP/XFP in 10s of milli-Watts (mW).
151
-
152
Reserved
No. Trap Name Objects Family Description