Alcatel-Lucent OmniSwitch 6450 - Page 353

SNMP Trap Information SNMP Traps Table
OmniSwitch 6250/6450 Switch Management Guide June 2013 page B-25
153
alaErpRingPortStatusChanged
alaErpRingId,
alaErpRing-
PortIfIndex,
alaErpRing-
PortStatus
bridge This trap is sent when the ring
port status is changed.
alaErpRingId—The Ring identifier that is unique in the bridge.
alaErpRingPortIfIndex—The interface index - either a bridge port, or an aggregated link within a bridge port,
to which ring port is configured.
alaErpRingPortStatus—The status of the ring port.
154
-
158
Reserved
159 alaDhcpClientAddressAddTrap alaDhcpClien-
tAddress
ip-helper This trap is sent when a new IP
address is assigned to a DHCP
client interface.
alaDhcpClientAddress—The current IP address of the DHCP client.
160
alaDhcpClientAddressExpiryTrap
ialaDhcpClien-
tAddress
ip-helper This trap is sent when the lease
time expires or when a DHCP
client unable to renew/rebind an
IP address.
alaDhcpClientAddress—The current IP address of the DHCP client.
161
alaDhcpClientAddressModifyTrap
alaDhcpClien-
tAddress,
alaDhcpClient-
NewAddress
ip-helper This trap is sent when the DHCP
client unable to obtain the exist-
ing IP address and a new IP
address is assigned to the DHCP
client.
alaDhcpClientAddress—The current IP address of the DHCP client.
alaDhcpClientNewAddress—The new IP address assigned to the DHCP client.
162
alaDyingGaspTrap
alaDying-
GaspSlot,
alaDyingGasp-
PowerSupply-
Type,
alaDyingGasp-
Time
interface This trap is sent when a switch
has lost all power.
alaDyingGaspSlot—The slot number of the chassis whose NI is going down.
alaDyingGaspPowerSupplyType—The type of the power supply.
alaDyingGaspTime—The time of the failure.
163
alaTestOamTxDoneTrap
alaTestOamCon-
figTestId,
alaTestOamCon-
figSourceEnd-
point,
alaTestOamCon-
figTestIdStatus
bridge After a configured time interval,
this trap is sent to the NMS from
Generator switch when the test
duration expires.
alaTestOamConfigTestId—A unique name to identify the entries in the table.
alaTestOamConfigSourceEndpoint—The the local or transmitting switch. For bidirectional test, this also iden-
tifies the analyzer switch.
alaTestOamConfigTestIdStatus—The test status (not started, running, stopped, ended).
No. Trap Name Objects Family Description