How to reset the password on Alcatel-Lucent Network Router?
If you've forgotten the password to access your Alcatel-Lucent Network Router, you can bypass the configuration by using micro-switch ‘5’, as detailed in the relevant section.
What to do if GE interfaces are established but there is no connectivity at the data layer on Alcatel-Lucent OmniAccess 5840?
If the LEDs on your Alcatel-Lucent Network Router indicate that the GE interfaces are established, yet there's no data connectivity, review the router's configuration, specifically the routes and IP addresses.
Why is my Alcatel-Lucent OmniAccess 5840 local console displaying garbage?
If your local console is only displaying garbage, ensure the terminal has the correct port configured and that the terminal configuration is set to 9600 8N1.
What to do if Alcatel-Lucent OmniAccess 5840 does not initialize and console displays WARM-UP text?
If your Alcatel-Lucent Network Router does not initialize and the console displays the WARM-UP text, verify that micro-switch ‘1’ is in the OFF position. You might need to reload the device BIOS and the routing application.
How to fix local console not responding on Alcatel-Lucent OmniAccess 5840?
If your local console isn't responding, verify that you're using the correct console cable and that it's properly connected to both the device and the asynchronous terminal. Ensure the terminal has the correct port configured, the terminal configuration is set to 9600 8N1, the console is not in an events process, and the device isn't being remotely accessed via telnet.
Why is Alcatel-Lucent OmniAccess 5840 Network Router very slow in displaying the application prompt?
If your Alcatel-Lucent Network Router is very slow in displaying the application prompt, check that micro-switch ‘3’ is in the OFF position.
How to troubleshoot Alcatel-Lucent OmniAccess 5840 when none of the LEDs light up?
If none of the LEDs light up on your Alcatel-Lucent Network Router, check the power supply, including the power source, ON/OFF switch, and main power outlet. Also, ensure all micro-switches are in the OFF position.
What to do if the local console does not respond on Alcatel-Lucent OmniAccess 5840 Network Router?
If the local console of your Alcatel-Lucent Network Router isn't responding, verify that you're using the correct console cable and that it's properly connected to both the device and the asynchronous terminal. Ensure the terminal has the correct port configured and that the terminal configuration is set to 9600 8N1. Also, check that the console isn't in an events process and that the device isn't being remotely accessed via telnet.
Why none of the LEDs light up on Alcatel-Lucent Network Router?
If none of the LEDs light up on your Alcatel-Lucent Network Router, check the power supply to the device, including the power source, ON/OFF switch, and the main power outlet. Also, make sure that all the micro-switches are in the OFF position.
Why is the local console displaying garbage on Alcatel-Lucent OmniAccess 5840?
If the local console of your Alcatel-Lucent Network Router is displaying garbage, ensure that the terminal has the correct port configured and that the terminal configuration is set to 9600 8N1.
General| Model | OmniAccess 5840 |
|---|---|
| Category | Network Router |
| Form Factor | Rack-mountable |
| VPN Support | Yes |
| Product Type | Router |
| Management | Web-based, CLI, SNMP |
| Power Supply | Redundant power supply options |
| Redundancy | Power Supply (optional) |
To Next Page