Alcatel-Lucent OmniSwitch 6860 - General Standards Compliance

OmniSwitch OS6860/OS6900/OS10K Troubleshooting Guide Part No.032996-00 Rev.A
AOS Release 7.X and 8.X January 2015
Alcatel-Lucent Page 112 of 148
BCM.0> d l3_ipmc
...
L3_IPMC.ipipe0[3]:
<VALID=1,REMOVE_SGLP_FROM_L3_BITMAP=0,L3_BITMAP_W1=0,L3_BITMAP_W0=0,L3_BITMAP=0x0000000000000000,
L2_BITMAP_W1=0xc00000,L2_BITMAP_W0=4,L2_BITMAP=0x00c0000000000004,HIGIG_TRUNK_OVERRIDE_PROFILE_PT
R=0,EVEN_PARITY=0>
OS6860 tables
L3_ENTRY table
Note:
Only applicable to AOS8 hardware platform
L3_ENTRY_2 table is empty by default. A new entry is created while adding a new entry in the multicast source
table (a forwarding entry doesn't have to exist, an example 239.0.0.1 stream):
BCM.0> d l3_entry_2
L3_ENTRY_2.ism0[1822]: <VALID_1=1,VALID_0=1,KEY
_TYPE_1=6,KEY_TYPE_0=6,IPV4MC:VRF_ID=0,IPV4MC:VLAN_ID=0x64,
IPV4MC:TRILL_NETWORK_RECEIVERS_PRESENT=0,IPV4MC:SOURCE_IP_ADDR=0xa1dc915,IPV4MC:RPE=0,
IPV4MC:RESERVED_209_144=0x000000000000000000,IPV4MC:RESERVED_104_97=0,IPV4MC:PRI=0,IPV4MC:L3_IIF=
0x64,
IPV4MC:L3MC_INDEX_RESERVED=0,IPV4MC:L3MC_INDEX=0,IPV4MC:KEY_0=0x00c9de000002143b922a0006,
IPV4MC:HASH_LSB=1,IPV4MC:GROUP_IP_ADDR=0xef000001,IPV4MC:DUMMY_0=0,IPV4MC:DST_DISCARD=0,IPV4MC:DA
TA_1=0x0000000000,
IPV4MC:CLASS_ID=0,HIT_BITS=1,HIT_2=0,HIT_1=0,HIT_0=1,EVEN_PARITY_1=1,EVEN_PARITY_0=1,
ENTRY_2_FROM_ENTRY_1_PART1=0x000000000000000000000000001b,ENTRY_2_FROM_ENTRY_1_PART0=0x0000032778
00000850ee48a8001b,>
L3_IPMC table
Note:
Only applicable to AOS8 hardware platforms
Default "L3_IPMC Table":
BCM.0> d l3_ipmc
L3_IPMC.ipipe0[0]:
<VALID=1,REMOVE_SGLP_FROM_L3_BITMAP=0,L3_BITMAP_W1=0,L3_BITMAP_W0=0,L3_BITMAP=0x0000000000000000,
L2_BITMAP_W1=0,L2_BITMAP_W0=0,L2_BITMAP=0x0000000000000000,HIGIG_TRUNK_OVERRIDE_PROFILE_PTR=0,EVE
N_PARITY=1>
L3_IPMC.ipipe0[1]:
<VALID=1,REMOVE_SGLP_FROM_L3_BITMAP=0,L3_BITMAP_W1=0,L3_BITMAP_W0=0,L3_BITMAP=0x0000000000000000,
L2_BITMAP_W1=0xffffff,L2_BITMAP_W0=0xfffffffe,L2_BITMAP=0x00fffffffffffffe,HIGIG_TRUNK_OVERRIDE_P
ROFILE_PTR=0,EVEN_PARITY=0>
L3_IPMC.ipipe0[2]:
<VALID=1,REMOVE_SGLP_FROM_L3_BITMAP=0,L3_BITMAP_W1=0,L3_BITMAP_W0=0,L3_BITMAP=0x0000000000000000,
L2_BITMAP_W1=0,L2_BITMAP_W0=1,L2_BITMAP=0x0000000000000001,HIGIG_TRUNK_OVERRIDE_PROFILE_PTR=0,EVE
N_PARITY=0>
A new entry is added to this table when a new IPMS forwarding entry is creatred (an example):
BCM.0> d l3_ipmc
...
L3_IPMC.ipipe0[3]:
<VALID=1,REMOVE_SGLP_FROM_L3_BITMAP=0,L3_BITMAP_W1=0,L3_BITMAP_W0=0,L3_BITMAP=0x0000000000000000,
L2_BITMAP_W1=0xc00000,L2_BITMAP_W0=0x1000,L2_BITMAP=0x00c0000000001000,HIGIG_TRUNK_OVERRIDE_PROFI
LE_PTR=0,EVEN_PARITY=0>