Alcatel-Lucent OmniSwitch 6860 - Advanced Troubleshooting

OmniSwitch OS6860/OS6900/OS10K Troubleshooting Guide Part No.032996-00 Rev.A
AOS Release 7.X and 8.X January 2015
Alcatel-Lucent Page 50 of 148
3 Dynamic 40000003 8 ENABLED DOWN 0 2
4 Dynamic 40000004 8 ENABLED UP 3 3
5 Static 40000005 2 DISABLED DOWN 0 0
show linkagg <id>
-> show linkagg agg 1
Static Aggregate
SNMP Id : 40000001,
Aggregate Number : 1,
SNMP Descriptor : Omnichannel Aggregate Number 1 ref 40000001 size 4,
Name : ,
Admin State : ENABLED,
Operational State : UP,
Aggregate Size : 4,
Number of Selected Ports : 4,
Number of Reserved Ports : 4,
Number of Attached Ports : 4,
Primary Port : 1/1/1
show linkagg port
-> show linkagg agg 1-5 port
Slot/Port Aggregate SNMP Id Status Agg Oper Link Prim
---------+-----------+--------+--------------+------+----+----+---------
1/1/16 Static 2016 CONFIGURED 1 UP UP YES
1/1/17 Static 2017 CONFIGURED 2 UP UP NO
3/1/1 Static 3001 CONFIGURED 3 UP UP NO
3/1/2 Static 3045 CONFIGURED 4 UP UP NO
3/1/3 Static 3069 CONFIGURED 5 UP UP NO
8.2. Advanced Troubleshooting
Check the LACP Rx and Tx counters :
OS6860-> debug show lacp counters port 1/1/1
Slot/Port LACP Tx LACP Rx LACP Err Marker RTx Marker Rx
---------+------------+------------+------------+------------+-------------
1/1/1 126 125 0 0 0
Detailed LACP logs:
swlog appid linkAggCmm subapp all level debug1
swlog appid linkAggNi subapp all level debug1
Even more detailed LACP logs:
swlog appid linkAggCmm subapp all level debug3
swlog appid linkAggNi subapp all level debug3
Optionally disable duplicates and increase SWLOG size:
no swlog duplicate-detect
swlog output flash-file-size 512
Gather logs:
show configuration snapshot linkagg
show linkagg port
show log swlog | grep LACP
show log swlog | grep linkagg
The debug logs should be disabled after gathering outputs: