EasyManua.ls Logo

Alcatel-Lucent OmniSwitch 6860 - Mounting the Switch and Airflow Guidelines

Alcatel-Lucent OmniSwitch 6860
148 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
OmniSwitch OS6860/OS6900/OS10K Troubleshooting Guide Part No.032996-00 Rev.A
AOS Release 7.X and 8.X January 2015
Alcatel-Lucent Page 49 of 148
An example configuration with allowed peering:
OS6860-> show configuration snapshot linkagg
! Link Aggregate:
linkagg lacp agg 1 size 2 admin-state enable
linkagg lacp agg 1 actor admin-key 1
linkagg lacp port 1/1/1 actor admin-key 1
linkagg lacp port 1/1/2 actor admin-key 1
LACP BPDU processing on software level
Once the packets were classified as "trap to CPU" on the ASIC level the packets were placed in CPU port
queue. There are 32 internal queues out of which 27 are used for LACP. The pktDriver receives the packet via
DMA transfer from the Broadcom ASIC, classifies the packet as LACP, and sends the packet to the LACP
module for further software processing.
Hash-control
Hash may be controlled for each linkagg separately using the following command:
OS6860-> linkagg lacp agg 1 hash ?
^
TUNNEL-PROTOCOL SOURCE-AND-DESTINATION-MAC
SOURCE-AND-DESTINATION-IP SOURCE-MAC SOURCE-IP
DESTINATION-MAC DESTINATION-IP
(Link Aggregation Command Set)
Support of 256 aggregates and up to 16 ports
A debug CLI command needs to be enabled to support 256 aggregates and up to 16 ports:
OS6860-> debug capability linkagg increase-agg-limit
Summary of the commands in this chapter is listed here:
_________________________________________________________________
show linkagg
show linkagg agg <linkagg id>
show linkagg agg <linkagg id> port
show configuration snapshot linkagg
show log swlog | grep LACP
show log swlog | grep linkagg
debug show lacp counters port <slot/port>
debug $(pidof lacpNi) "call la_ni_lacp_port_stats_prt (-1)"
d chg trunk_group
show c ge28
g RDBGC0.ge28
g drop_pkt_cnt_ing.ge28
__________________________________________________________________
8.1. Basic Troubleshooting
show linkagg
-> show linkagg
Number Aggregate SNMP Id Size Admin State Oper State Att/Sel Ports
-------+----------+--------+----+-------------+-------------+--------+-----
1 Static 40000001 8 ENABLED UP 2 2
2 Dynamic 40000002 4 ENABLED DOWN 0 0

Table of Contents

Other manuals for Alcatel-Lucent OmniSwitch 6860

Related product manuals