Configuring Loopback Detection Verifying the LBD Configuration
OmniSwitch AOS Release 8 Network Configuration Guide December 2017 page 7-12
Verifying the LBD Configuration
To display LBD configuration and statistics information, use the show commands listed below:
For more information about the resulting display from these commands, see the OmniSwitch AOS Release
8 CLI Reference Guide.
loopback-detection autorecovery-
timer
Displays the global LBD configuration information for the switch.
show loopback-detection port Displays LBD configuration information for all ports on the switch.
show loopback-detection statistics
port
Displays LBD statistics information for a specific port on the switch.
To Next Page
Loading...
