17
5.2.3
You can set the network search mode to either Auto or Manual, and change the
network mode to Auto, 2G only, 3G only or 4G only. Make sure that you click
Apply after making any changes.
5.3 WAN
5.3.1 WAN status
Here you can view detailed information on the wide area network (WAN),
including IP address, subnet mask, gateway, DNS server, etc.
5.3.2
Set up the WAN connection mode and parameters here. You can set the
connection mode to PPPoE or static IP.
PPPoE: PPPoE stands for Point-to-Point Protocol over Ethernet. This is a network
protocol that is mainly used for DSL services whereby individual users connect
to a modem using an Ethernet connection. Enter the username and password
provided by your network service provider and click Apply.
Static IP: Access the internet using a fixed IP address, subnet mask, gateway IP
address and Primary DNS server. These should all be provided by your network
service provider.
5.3.3 MAC Clone
Using the MAC Clone function, multiple clients can connect to the Cat7 Router
and access the internet.
Your current MAC address is displayed here. Click to set a new MAC
address. Click Clone to copy your host MAC address.
5.4 DHCP
Dynamic Host Configuration Protocol (DHCP) is a client /server protocol that
automatically provides you with an Internet Protocol (IP) host. The IP address
and related configuration settings such as subnet mask and default gateway are
all automatically assigned. Select DHCP and click Apply.
The default Gateway address is 192.168.1.1.
The default Subnet Mask is 255.255.255.0.
To Next Page
Loading...
Need help?
General
