REF: WM4 User Manual V7.docx Page 27 © Alcolizer Technology
10 Logs
10.1 View
The View contains the log records which consist of one or more pieces of information. Each
record will show a unique log record id entry followed by the date and time and a brief
description of the logged event.
Selecting an item in this panel a more detailed view of the selected log record is also
presented below the list of log records.
The log record can contain any of the following events:
• Calibration Failed. Instrument calibration was not successful.
• Calibration Gas Bottle Changed. The calibration gas bottle was changed and service life
was reset.
• Calibration Successful. Instrument calibration was successful.
• Result. The result of a breath test.
• System Shutdown. The instrument was shut down (to be powered off or rebooted).
• System Started. The instrument was started.
• System Time Changed. The wallmount's time or date was changed.
• Fault Cleared. A fault status item cleared.
• Fault Set. A fault status item set.
• Alert Cleared. An alert status item cleared.
• Alert Set. An alert status item set.
• Warning Cleared. A warning status item cleared.
• Warning Set. A warning status item set.
• Notice Cleared. A notice status item cleared.
• Notice Set. A notice status item set.
• Breath Analysis Block Set. Data analysis is disabled.
• Breath Analysis Block Cleared. Data analysis enabled.
• Fuel Cell Changed. Fuel cell changed, configuration and data was reset.
NOTE
If the instrument has a camera installed and enabled then there will also be a photo panel
showing any photos associated with the selected log record.
If the panel does not have focus it will act as a slideshow over the available images. If the
panel has focus the arrow keys can be used to navigate to a specific photo.
To Next Page
Loading...
