112
ALDE HEATING OPERATING INSTRUCTIONS
Alde 3020 - 113
Colour Touch Operating
Instruction
The Alde 3020 Compact HE control panel
has two hard buttons and a non-capacitive,
colour touchscreen interface. The soft buttons
displayed on the screen are operated by
touching the screen with your finger.
! WARNING: Please read the Alde 3020
Compact HE operating instructions fully
before using the system.
Starting the System
3020
High Efficiency
1. Both the control panel and boiler are off.
2. To start the system, press the Power button
on the control panel. The Splash Screen is
displayed and green LED is lit. The boiler will
now start with the previously saved settings
(factory settings by default).
The system will now be drawing variable
0.1–1.5 A of current from the 12 V supply.
Standby Screen
The Standby Screen is displayed after the
Splash Screen. This screen contains useful
information about the status of your heating
system.
NB: If Standby Screen is set to “Dark” in
Backlight settings, the Standby Screen will not
be displayed, the screen will be dark unless
touched.
A. Clock is enabled. Day of the week and time
shown.
B. Outdoor temperature. [Optional outdoor
temperature sensor required.]
C. Room temperature. Measured at the control
panel. [Optional discrete room temperature
sensors available.]
D. Central heating circulation pump is active.
E. Delayed Start/Cycle is enabled.
F. Day Mode active.
G. Gas cylinder status. Full/empty and EisEx
mode shown. [Additional accessories
required.]
H. Night Mode active.
I. 230 V supply. If not displayed, the boiler is
not receiving 230 V supply.
J. Power button. Press to switch system on-
off. Lit green LED indicates system is on.
K. MENU button. Press to access Main Menu
from Standby Screen or Settings Menu.
To Next Page
Loading...
