FITTED EQUIPMENT
174
Step on hitch cover
Where a step on hitch cover is fitted,
customers are reminded only to stand on the
designated areas, identified with black anti-slip
matting. Stepping elsewhere on the hitch
cover may result in damage to the hitch cover.
Models without a step on hitch cover are
not suitable for standing on and failure to
follow these simple instructions may result
in premature failure or cracking which will
not be covered by any guarantees (including
extended warranties).
Cycle racks
The Swift Group allows the fitment of two
cycle rack carrier and we have made provision
for this with two pre positioned mounting rails
fitted to the rear of your caravan. These are
spaced at either 800mm or 850mm apart.
Below are the racks which can be purchased
from Thule, which are compatible with the
pre-fitted rails.
The Swift Group only recommends a Thule
cycle carrier which will conveniently clip in to
the pre-installed mounting rail. The maximum
weight which can be mounted on the carrier
is 50kg.
Caravan motor movers
The design and fitment of a caravan motor
mover shall be in accordance with the NCC
Code of Practice 305 and you should ensure
you receive a signed installation certificate of
compliance from the installer.
Failure to do so may invalidate
your warranty
Depending on specification, the wiring in the
caravan battery box may feature connections
suitable for use with an aftermarket motor
installation. When fitted, this will feature an
isolation switch, fusing, and heavy duty wiring,
terminated in two connection points within the
caravan battery box.
STEP ON HITCH/CYCLE RACK
Thule Bike carriers
Thule Bike carrier type Thule Excellent
standard version
Thule Elite G2
standard version
Thule Sport G2
standard version
Thule reference 309821 306560 307126
Capacity (# bikes) 2+1+1 2+1+1 2 + 1
Max load to be placed on
the rack (kg)
50 50 50
Max individual bike weight (kg) 30 30 19
800mm Fixing rail spacing Yes Yes Yes
850mm Fixing rail spacing Yes Yes Yes
To Next Page
Loading...
Need help?
General
